Honda CRF50F 2007 Owner's Manual page 100

3. Rotate the wheel slowly to see if it appears
to ''wobble.'' If it does, the rim is out of
round or not ''true.'' If the wobble is
noticeable, see your Honda dealer for
inspection.
Front Wheel Removal
(4)
(2)
(1)
(3)
(1) brake adjusting nut
(2) brake cable
(3) brake arm
(6)
(5)
(4) front axle nut
(5) lug
(6) slot
Removal
1. Raise the front wheel off the ground by
placing a maintenance stand or support block
under the engine. Secure the rear of the
motorcycle with tie-down straps.
2. Remove the front fork protector (page
3. Unscrew the front brake adjusting nut ( ).
Pull the front brake lever in and disconnect
the brake cable ( ) from the brake arm ( ). 2
4. Remove the front axle nut ( ) and front axle
shaft.
5. Remove the wheel.
6. Pull the brake assembly out carefully.
Take care to prevent getting grease, oil, or dirt
on the brake shoe surfaces. This can cause poor
brake performance or rapid brake shoe wear
after reassembly.
Servicing Your Honda
Wheels
56 ).
1
3
4
91