Troubleshooting - Panasonic KX-PRL262 Operating Instructions Manual

Display message
Requires
subscription
to Caller ID.
Use
rechargeable
battery.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
The handset display is blank or
dark.
For assistance, please visit http://www.panasonic.com/help
Cause/solution
R You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
R A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 3, 7.
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 10).
R Check the connections (page 10).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 42).
R The handset is in screen saver mode (page 16). Activate
the handset display again by:
– pressing M
– pressing MOFFN at all other times.
R "LCD backlight" is set to "Off" while on charge.
Change the setting (page 37).
Useful Information
N when on a call.
61