Troubleshooting Tips - Magnavox P-08PE Owner's Manual

TROUBLESHOOTING TIPS

TROUBLE SHOOTING
PROBLEM
1. Unit does not start
when pressing
ON/OFF button
2. Not cool enough
3 . Noisy or vibration
4. Gurgling sound
5. Power shut off at
Heating mode
The rating data indicated on the energy label is based
on the testing condition of installing the un-extended
air exhaust duct without adaptor A & B (The duct and
the adaptor A & B are listed in the accessories chart
of the Instruction Manual).
SOLUTION
- P1 appears in the display window. Drain the water in the bottom tray.
- Room temperature is lower than the set temperature.(Cooling mode)
Reset the temperature.
- The windows or doors in the room are not closed.
Make sure all the windows and doors are closed.
- There are heat sources inside the room.
Remove the heat sources if possible.
- Exhaust air duct is not connected or blocked.
Connect the duct and make sure it can function properly.
- Temperature setting is too high.
- Air filter is blocked by dust.
- The ground is not level or not flat enough.
Place the unit on a flat, level ground if possible.
- The sound comes from the flowing of the refrigerant inside the air-conditioner.
This is normal.
- The automatic over heat protection function. When the temperature
at the air outlet exceed s 70 C/158 F,th e de vice will st op.
Switch on again after the unit has cool down.
NOTE
15
Decrease the set temperature.
Clean the air filter.
O O