Connecting To Web-Based Interface - D-Link DSL-2740U User Manual

DSL-2740U ADSL/Ethernet Router with Wi-Fi and Built-in Switch
User Manual
3. Search for available wireless networks.
4. In the opened Wireless Network Connection window select the needed wireless
network (DSL-2740U) and click the Connect button.
After that the Wireless Network Connection Status window appears.
If you perform initial configuration of the router via Wi-Fi connection, note that
!
immediately after changing the wireless default settings you will need to reconfigure the
wireless connection using the newly specified settings.

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (for example, create an interface to connect to the Internet, change the
parameters of the wireless network, specify the settings of the firewall, edit the password for the
administrator account, etc.)
1. Start a web browser (see the Before You Begin section, page 12).
2. In the address bar of the web browser, enter the IP address of the router (by default, the
following IP address is specified: 192.168.1.1). Press the Enter key.
Figure 7. Connecting to the web-based interface of the DSL-2740U device.
3. On the opened page, enter the username (login) and password for the administrator account
(by default, the following username and password are specified: admin, admin). Then
click the Enter button.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the router,
make sure that you have properly connected the router to your computer.
After successful registration the system statistics page opens. The page displays general information
on the router and its software.
Figure 8. The login page.
Page 16 of 94
Installation and Connection