Using The Side Burner; Side Burner Igniter Wire Assembly - Jenn-Air 720-0337 User Manual

USING THE SIDE BURNER

Inspect the gas supply hose prior to turning on the
gas. If there is evidence of cuts, wear or abrasion, it
must be replaced prior to use. Do not use the side
burner if gas odor is present.
WARNING
When lighting, always keep your face and body as
far away from the burner as possible.
LIGHTING INSTRUCTIONS
1. Open the top cover or lid. Remove any cooking
utensils that are near the burner grate.
2. Turn the control knob counterclockwise to the
"IGNITE/HI" setting and then push the control
knob in. You should hear a "clicking" sound if
the electronic ignition system is working
properly.
3. If the burner does not light within 4 seconds,
turn the control knob to the "OFF" position.

SIDE BURNER IGNITER WIRE ASSEMBLY

The side burner igniter wire is pre-assembled. If you find it loose, please follow the assembly instructions below.
1. Connect the side burner igniter wire to the side burner gas valve as shown in figure 1.
Figure 1
2. Push and turn the side burner control knob to "IGNITE/HI". Look for a spark at the side burner igniter under
the cooking grid to make sure the connection is good.
Figure 2
4. If the smell of gas is detected and the igniter is
not functioning, immediately turn the control
knob to the "OFF" position.
5. Allow 5 minutes for any accumulated gas to
dissipate. If the side burner igniter will not
function, follow the match lighting instructions
below.
MATCH LIGHTING
1. Insert a match into the lighting rod. Ignite the
match and place near the side burner ports.
2. Turn the control knob counterclockwise to the
"IGNITE / HI" setting. The side burner should
light immediately.
3. Rotate the control knob to the desired setting.
21