Table of Contents
Advertisement
COMPONENTS
Disconnect the 8 pin
connector from P.C.B.
(Refer to schemetic diagram)
RELAY 2, RELAY 3
OF P.C.B.
(Wire leads removed.)
Note: Relay
Relay 1: Fan motor
Turntable motor
Oven lamp
Relay 2: Microwave
Relay 3: Grill
FAN MOTOR
(Wire leads removed)
TURNTABLE
MOTOR
(Wire leads removed)
NOTE : • A MICROWAVE LEAKAGE TEST MUST ALWAYS BE PERFORMED WHEN THE UNIT IS
SERVICED FOR ANY REASON.
• MAKE SURE THE WIRE LEADS ARE IN THE CORRECT POSITION.
• WHEN REMOVING THE WIRE LEADS FROM THE PARTS, BE SURE TO GRASP THE
CONNECTOR, NOT THE WIRES.
TEST PROCEDURE
Check for P.C.B. connector.
1
3
5
Relay 3
Relay 1
Relay 2
Measure the resistance.
(Ohm-meter scale: R x 1)
Measure the resistance.
(Ohm-meter scale: R x 1000)
5-11
RESULTS
Cooking Start
Cooking Start
Normal: Approx. 200 ~400 ohm
A
Approx. 30 ~ 50 ohm
B
Approx. 300 ~ 500 ohm
A
Abnormal: Infinite or several
ohm.
B
Normal: Approx. 10~20 kohm
Abnormal: Infinite or several
ohm.
OFF
OFF
Advertisement
Table of Contents
