Advanced Functions - LG LV4947 User Manual

GC981P1.BAUTLLS_ENG 3/9/09

Advanced functions

Your Video recorder has some advanced operations with features you may find useful.
CM (Commercial
Message) Skip
This enables you to skip past small
sections of the video tape, such as
commercial messages, television
adverts or film trailers.
Press the CM SKIP button on the
remote control, during play.
Each subsequent press of the button
increases the amount of the tape
which is skipped by 30 seconds, up
to a total of three minutes
(180 seconds). After the chosen time
has passed normal play will
automatically resume.
OPR (Optimum Picture
Response)
This enhances the picture from the
video tape by adjusting to the
condition of the video tape. If you feel
that the picture needs adjusting you
can manually change the OPR
setting.
You can only set OPR when a tape is
playing in the Video recorder.
2:22 PM Page 11
on your Video Recorder
1 Press to enter the main menu.
2 Use 1 or 2 to select OPR then
press OK.
OFF
SOFT
SHARP
OPR
i
3 Use the 3 or 4 buttons to select
OFF, SOFT or SHARP.
4 Press to exit the menus.
Colour standards
Your Video Recorder uses dual
colour standards, PAL B/G and
SECAM D/K. During play your Video
Recorder should select the Colour
System automatically, however if you
experience problems you may need
to do it manually.
1 Press to enter the main menu.
2 Use 1 or 2 to select SYSTEM
then press OK.
3 Use 3 or 4 to select the colour
system used in your recording.
AUTO
PAL
SYS-
MESECAM TEM
i
4 Use 1 or 2 to select the RF
AUDIO.
5 Use 3 or 4 to select the channel
of audio output according to your
TV type.
RF I/I
RF B/G
SYS-
RF D/K TEM
i
6 Press to exit the menus.
Setting the clock
The Video Recorder uses a 24 hour
clock, so that for example 1 pm is
represented as 13:00.
Single digit numbers should be
entered with a 0 in front for
instance, 01.
11
1 Press to enter the main menu.
Use the 1 or 2 buttons to select
TIME DATE then press OK.
2 The Auto Adjust mode can be set
to OFF by using the 3 or 4
buttons. Press OK to adjust the
date and time.
HH MN DD MM YY
- - : - - - - . - - . - - - - -
1 2
TIME
i
DATE
3 Use the numbered buttons on the
remote control to enter the the
HOURS, MINUTES, DAY,
MONTH and YEAR.
The day of the week will appear
automatically once the date has
been entered. If you make a
mistake use 1 or 2 to select the
item and re-enter the details.
4 Once you are satisfied press to
store your settings.
LV4947 Only : If Auto Adjust is on
and the signal is sufficiently strong,
the clock settings will be automati
cally checked against teletext and
adjusted as necessary.