Westinghouse WRC613S Installation And User Manual page 10

INSTALLATION
7. Electrical connection
Check that the installation complies with the standards
of local building, gas and electrical authorities. Before
connecting to the mains supply ensure that the mains
voltage corresponds to the voltage on the rating plate
inside the rangehood.
8. Installation of telescopic flue covers
Separate the inner and outer flue covers, and carefully
remove the protective coating from both. Carefully
reassemble the upper and lower flue covers sections by
sliding the inner into the outer flue cover. Carefully lower
the assembled upper and lower flue covers onto the top
of the rangehood body, and insert the flue cover into the
rangehood body approximately 5mm. Fix upper flue cover
to the wall mounting bracket with screws supplied. Ensure
that the upper section is extended.
10
Fig. 13
CAUTION
Care must be taken to ensure the screws are not cross
threaded when attaching the upper flue cover.
If installed in recirculating mode, insert the optional carbon
filter (included in recirculation kit AR910RK).
To complete the rangehood installation, insert the filters to
the underside of the hood body. Place back edge of filter
into position and push up front edge so that the filter clips
into place.
Your Westinghouse rangehood is now ready to use.
Fig. 14
Fig. 15