Table of Contents
Advertisement
Warning
This appliance must be
earthed
If the fitted moulded plug is not
suitable for your socket, then the plug
should be cut off and an appropriate
plug fitted.
Destroy the old plug, which is cut
off as a plug with a bared cord could
cause a shock hazard if inserted into a
socket elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the
fuse need to be replaced an ASTA
approved BS1362 fuse of the same
rating must be used. Do not forget to
refit the fuse cover. In the event of
losing the fuse cover, the plug must
not be used until a replacement fuse
cover has been fitted. Colour of the
replacement fuse cover must be the
same colour as that visible on the
pin face of the plug. Fuse covers are
available from any good electrical
store.
Important
Fitting a different plug
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals on
your plug, proceed as follows:
1.
Connect the green - yellow or
green (earth) wire to the terminal
in the plug marked 'E' or with the
symbol
or coloured green
and yellow or green.
2. Connect the blue (neutral) wire to
the terminal in the plug marked
'N' or coloured black.
3. Connect the brown (live) wire to
the terminal in the plug marked 'L'
or coloured red.
With the alternative plugs a 13A fuse
must be fitted either in the plug or
adaptor or in the main fuse box. If in
doubt contact a qualified electrician.
Green and yellow
or green
N
Blue or
black
Water inlet hose connection
Make sure your plumbing is suitable
to install your new dishwasher. If in
doubt contact a qualified plumber.
The appliance must be connected
to the water mains using the new
hose set supplied with your new
dishwasher. Old hose sets must
not be re-used.
The water pressure coming from
the water mains supply must be a
minimum of 0.3 and a maximum of 10
bars.
8 GB
L
Brown or red
Advertisement
Table of Contents
