Integra DTR-20.4 Instruction Manual page 77

Important Note Regarding Video Playback
The AV receiver can upconvert component video and
composite video sources for display on a TV connected to
HDMI OUT. However, if the picture quality of the source
is poor, upconversion may make the picture worse or
disappear altogether.
In this case, try the following:
1 If the video source is connected to a component
video input, connect your TV to COMPONENT
VIDEO OUT.
If the video source is connected to a composite video
input, connect your TV to MONITOR OUT V.
2 On the main menu, select "Input/Output Assign",
and then select "Component Video Input"
(➔ page 47).
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to "IN1".
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to "IN2".
If the video source is connected to a composite video
input, select the relevant input selector, and assign it to
"- - - - -".
Tip
• To by-pass the upconversion, set the "Picture Mode" setting to
"Direct" (➔ page 54).
En-77
Appendix