Audio Adjust - Integra DTR-20.4 Instruction Manual

Speaker Distance
This setting is set automatically by Audyssey 2EQ
Room Correction and Speaker Setup (➔ page 30).
Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener's ears as the sound designer intended.
■
Unit
feet:
Distances can be set in feet. Range: 0.2ft to 30.0ft in
0.2 foot steps.
meters:
Distances can be set in meters. Range: 0.06m to
9.00m in 0.06 meter steps.
(The default setting varies from country to country.)
■
Left, Front High Left, Center, Front High Right,
Right, Surround Right, Surround Back Right,
Surround Back Left, Surround Left, Subwoofer
Specify the distance from each speaker to your
listening position.
Note
• Speakers that you set to "No" or "None" in
"Speaker Configuration" cannot be selected (➔ page 48).
Level Calibration
® This setting is set automatically by Audyssey 2EQ Room
Correction and Speaker Setup (➔ page 30).
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Note
• These settings cannot be calibrated in either of the following
cases:
– The "Audio TV Out" setting is set to "On" (➔ page 59).
– "HDMI Control(RIHD)" is set to "On" (➔ page 58) and
you're listening through your TV speakers.
– The AV receiver is muted.
■
Left, Front High Left, Center
Right, Surround Right, Surround Back Right,
Surround Back Left, Surround Left
–12dB to 0dB to +12dB in 1 dB steps.
■
Subwoofer
*1
–15dB to 0dB to +12dB in 1 dB steps.
Note
• Speakers that you set to "No" or "None" in
"Speaker Configuration" cannot be selected (➔ page 48).
*1 For the center speaker and subwoofer, the level settings made
by using the Quick Setup are saved in this menu (➔ page 42).
Tip
• If you're using a handheld sound level meter, adjust the level of
each speaker so that it reads 75 dB SPL at the listening position,
measured with C-weighting and slow reading.
En-49

Audio Adjust

1
Main menu
With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
Multiplex/Mono
■
Multiplex
Input Channel
Main
Sub
, Front High Right,
*1
Main/Sub
This setting determines which channel of a stereo
multiplex source is output. Use it to select audio channels
or languages with multiplex sources, multilingual TV
broadcasts, and so on.
■
Mono
Input Channel
Left + Right
Left
Right
This setting specifies the channel to be used for playing
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.
Advanced Operations
2 3 4 5
"Setup"
Audio Adjust