Desa BFLT18 Owner's Operation And Installation Manual page 9

HEARTH KIT ASSEMBLY AND
INSTALLATION
Kit Assembly - Single and Dual-Flame
Only
1. Determine which side gas line will be
coming into fireplace.
NOTICE: Triple-burner mod-
els BFLT18 and BFLT24 come
preassembled with gas inlet
on right side of burner pan.
DO NOT attempt to reposition
burner on triple-burner models.
If your fireplace supply is on
the left side, a longer 3/8" flex
line should be purchased and
routed behind burner pan and
away from flame area.
2. Using a hammer and screw driver, re-
move knockout plug from side of pan that
corresponds to gas line (see Figure 6).
3. Unscrew burner inlet fitting from burner
manifold.
4. Place burner manifold in pan with thread-
ed opening facing open knockout plug.
5. Using thread sealant (resistant to the ac-
tion of propane/LP gas) on larger end of
fitting, screw burner inlet fitting through
hole and into burner manifold (see Fig-
ure 6). Tighten using a wrench. If using
propane/LP gas, see Propane/LP Gas
Conversion, page 11.
6. Using burner clamp, screw, and nut pro-
vided, assemble clamp to pan ("U" style
and triple burners only). This will hold
burner manifold in place.
7. If using optional GA9050A-1 kit, go to
Optional GA9050A-1 On/Off Safety
Valve/Pilot Kit , page 10, for installation
instructions. If using optional GA9150A
kit, follow instructions included with kit for
installation and operation.
901265-01S
INSTALLATION
Continued
Knockout
Plugs
Burner
Manifold
Knockout
Plugs
Front
Burner
Burner Pan
(Front)
www.desatech.com
Burner Manifold
Burner Pan
(Front)
SINGLE-BURNER
Nut
Burner Pan
(Front)
Screw
DUAL-FLAME
Burner
Manifold
TRIPLE-BURNER
Figure 6 - Installing Burner
Burner Inlet
Fitting
Burner Clamp
Burner Inlet
Fitting
Gas Connection
Must Be On
Right Side For
Triple Burner
Burner Inlet
Fitting
9