Omron Gentle Temp 520 Manual page 11

MC-520-E_A_M_main.book Page 11 Monday, April 16, 2018 5:03 PM
4. Troubleshooting and Maintenance
4.1
The Icons and Error Messages
In case of any of the below problems occur during measurement, first check that no other electrical device is
within 30cm. If the problem persists, please refer to the table below.
Error Display Cause
Device stabilization in process.
Battery is low.
Probe cover is not attached correctly.
Measurement before device stabilization.
The device is showing a rapid ambient
temperature change.
The ambient temperature is not within
the range between 10°C and 40°C
(50°F - 104°F).
Remedy
Wait until stops flashing.
Replace the battery.
(Refer to section 4.3)
Attach the probe cover again until stops flashing.
Wait until stops flashing.
Allow the thermometer to rest in a room for at least
30 minutes at room temperature: 10°C and 40°C
(50°F - 104°F).
Allow the thermometer to rest in a room for at least
30 minutes at room temperature: 10°C and 40°C
(50°F - 104°F).
EN
11