Installing The Holster; Installing External Accessories; Charging The Battery Pack - Midland BR180 Owner's Manual

INSTALLING THE HOLSTER

With the back of the radio facing you, align the bottom of the holster with the bottom of the radio and
push the top of the holster over the top of the radio until the Lock Tab snaps into place.
To remove the Holster, push down on the Lock Tab until it releases the radio.

INSTALLING EXTERNAL ACCESSORIES

Pull the accessory jack cover to the side exposing the speaker/mic jacks.
Insert the accessory plug into the speaker/mic jack, making sure it is securely in place and has made
a good connection.

CHARGING THE BATTERY PACK

Your radio is equipped with a Lithium-Ion battery pack which can be recharged by inserting the radio
or battery into the desktop charger (as described below). You should charge the battery pack when the
Charge Battery Alert comes on, and remove the radio from the charger when the charging is finished.
To charge using the Desktop Charger:
1. Plug the DC barrel plug on the adaptor cord into the connector on the back of the charging base.
2. Plug the AC adaptor into a 120V AC wall outlet, making sure the AC outlet has power.
• The charger's LED's turns green when power is present.
3. Make sure the battery contacts and charge terminals are clean and in good condition.
4. Slide the radio with installed battery, or a spare battery without radio, into the charger being careful
to align the slots on the battery with the tabs inside the charger base.
5. The charger LED's will turn red and begin charging the battery.
6. Charging time depends on the charge level of the battery.
Confidential
BR180 Owner's Manual
FPO
Update drawing with accessory door open
Lock Tab
7