Advertisement
EMPTY THE TANK
WARNING: To reduce the risk of injury from
accidental starting, unplug power cord before
emptying dust tank.
1.
Remove power head assembly of wet/dry vacuum
by pulling outward on lid clips located on each side
of vacuum. Lift off power head assembly.
2. Dump tank contents into proper waste disposal
container.
3. Liquids may be emptied through tank drain. To
empty, turn off unit and remove plug from wall
outlet. Remove drain cap and deposit liquid waste
contents in suitable drain. After tank is empty, return
drain cap to its original position. To continue use,
plug cord into wall outlet and turn on the unit.
(See Figure 6)
Figure 6
PAGE 6 OF 7
OPERATION CONTINUED
Drain
BLOWING OPERATION
WARNING: Always wear safety goggles
complying with ANSI Z87.1 (or in Canada
CSA Z94.3) when using as a blower.
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
CAUTION: Wear a dust mask if blowing creates
dust that might be inhaled.
CAUTION: To reduce the risk of hearing loss,
wear ear protectors when using the vac/blower
for extended hours or when using it in a noisy
area.
1.
Locate blowing port on the vac.
2. Insert one end of the 1⁄" x 7' hose into the blowing
port. (See Figure 7)
3. Turn vacuum "ON".
Figure 7
Blowing
Port
0321 IH-8931
Advertisement
