Ignition Lead - Stihl MS 290 Manual

– Use a pointed tool to pierce the
center of the ignition lead's
insulation, about 15 mm from the
end of the lead.
: Pinch the hook of the leg spring
into the center of the lead (arrow).
: Pull the lead back into the spark
plug boot so that the leg spring
locates properly inside it (arrow).
MS 290, MS 310, MS 390
Install all other parts in the reverse
sequence.
7.2.1

Ignition Lead

– Troubleshooting – b 4.4
– Remove the ignition module,
b 7.1.2
: Pull the grommet (arrow)
downwards and off the ignition
lead.
: Pull the ignition lead (1) upwards
and out of the tank housing.
– Remove the spark plug boot,
b 7.2
Install in the reverse sequence.
– Cut new ignition lead to a length
of 175 mm.
: Use a pointed tool to pierce the
center of the other end of the
ignition lead which screws into
the module.
1
41