Before Use; Charging The Battery Pack (See Fig . A); Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside PDSSA 20-Li A1 Translation Of The Original Instructions

Before use

Charging the battery pack
(see fig . A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket . The
control LED lights up red .
♦ The green control LED
charging process is complete and the battery
pack is ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
♦ Insert the battery pack
appliance .
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
PDSSA 20-Li A1
to the rapid
(see Fig . A) .
indicates that the
flashes, this means
has overheated and
both
back into the
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Push the rotation direction switch
the middle position (lock) . Allow the battery
pack to click into the handle .
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram) .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Use

Switching on and off

Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in . The LED work
light lights up when the ON/OFF switch
is depressed lightly or fully . This allows for illumi-
nation of the work area in low lighting .
Switching off
♦ Release the ON/OFF switch
appliance .
is
into
and remove the
to
as follows:
to switch off the
GB │ IE │ NI │ 7 ■