Kenmore 146.22126910 Use & Care Manual page 26

Electronic Ignition Module
7
□ Take apart an Electronic ignition module as shown. (A)
□ Attach electronic ignition module through mounting hole on left side panel. (B)
□ Insert rubber gasket followed with plastic lock nut and tighten by hand. (C)
□ Insert (1) AA battery (provided in hardware pack) into battery slot with positive end (+) facing outward. (D)
□ Screw igniter cap back onto panel. (E)
□ Repeat the above steps to attach the other Electronic ignition module to the right side panel.
A
B
C
E
D
26