Kenmore 146.22126910 Use & Care Manual page 21

3 Grill Head to Cart
CAUTION: To avoid possible injury, two people are required to lift and position the grill head onto the
cart.
Step 1: Remove the tie wraps of the regulator. Make sure the regulator stays outside of the Cart when installing.
□
CAUTION: Do not place the Regulator inside the cart!
Step 2 & 3 &4: Remove the tie wraps from the wires. Position the Grill Head on the Cart so that the support tabs
□
jutting up from the top of the cart bars are on the outside of the Head. Keep the wires inside of the Cart.
□ Step 5: Secure the Head to the top of the Cart by tightening (2) M6*13 screws through the Support Tabs on
each side of Cart and into the Head.
M6 x13 Screw
Qty: 4pcs
Step 4
Step 3
Step 5
Step 6
Support Tab
Step 2
Step 1
21