Installation; Wrist Strap, Belt Clip, Spkr/Mic Jack And Waterproof Pouch; Batteries And Charger Jack; Customer Assistance Caution - Cobra MRHH100 Owner's Manual

Intro Operation Customer
Assistance
Wrist Strap, Belt Clip, Spkr/Mic
Jack And Waterproof Pouch

Installation

Customer
Installation
Assistance

Wrist Strap, Belt Clip, Spkr/Mic Jack And Waterproof Pouch

Secondary Icons
The radio is shipped with a Wrist Strap, Belt Clip and Waterproof Pouch in the
package. The Speaker/Microphone Jack can be used with additional accessories.
Contact your local Cobra ® dealer or Cobra
Notice Caution
Wrist Strap
Wrist Strap
Your radio comes with the Wrist Strap already
attached. It can be easily removed if you choose
not to use it.
Belt Clip
Belt Clip
Use the Belt Clip to carry your radio around with
you. Simply squeeze the clip and place it where
you prefer.
External Speaker/Microphone Jack
Your radio can be fitted with an optional External Speaker/Microphone
(not included), freeing your hands for other tasks. Contact your local Cobra
dealer or Cobra ® directly for optional accessories.
To Attach The External Speaker/Microphone:
Speaker/Microphone Tab
1. Open the speaker/microphone tab on top
of the radio.
2. Insert the plug into the speaker/microphone jack.
Waterproof Pouch
Use the included Waterproof Pouch to not only keep your radio dry,
but also dust and dirt free.
To Enclose The Radio In The Waterproof Pouch:
Waterproof Pouch
1. With the CobraMarine
slip radio, face up, into opening under
Velcro ® flap at the bottom of the
waterproof pouch.
2. Turn pouch and radio over so that the
CobraMarine
3. Roll bottom of pouch (between Velcro
pieces) towards upper piece of Velcro
4. Secure bottom piece of Velcro
upper piece of Velcro
24 English
Warranty
® directly for optional accessories.
Warning
®
™ logo facing up,
™ logo is facing down.
®
® .
® to
® .
Intro Operation
Installation
Installation

Batteries And Charger Jack

•
Secondary Icons
Remove Belt Clip
Notice
Remove Battery Cover
Main Icons
Main Icons
Intro
Insert Four (4) Batteries
Intro Operation Customer
Assistance
Secondary Icons
Customer
Installation
Assistance
Secondary Icons
Notice Caution
Fully Charged
Customer Warranty
Assistance
Batteries And Charger Jack
Customer
Assistance
Installing The Batteries (Not Included)
To Install Or Replace Batteries:
1. Remove belt clip by releasing belt clip
Caution latch and sliding clip down. Warning
2. Pull down on the battery door latch to
remove the battery compartment cover.
3. Insert four (4) AAA batteries. (Always use high
quality alkaline batteries.) Position batteries
according to polarity markings.
4. Replace battery compartment cover and belt clip.
Charger Jack
When the optional Cobra ® NiCD rechargeable batteries
(part No. NICB) are used, the batteries can be charged
Operation Customer Warranty
using the optional Cobra ® wall mount charger (part
Assistance
No. WWC). Simply place the Cobra ® NiCD rechargeable
batteries (part No. NICB) in the battery compartment,
open the charge tab on the side of the unit and insert
Customer
Installation
Warranty
Assistance
the plug into the Charger Jack to start charging. The
batteries should be fully charged in about 15 hours.
NOTE
Contact your local Cobra ® dealer or Cobra
Notice Caution Warning
directly for optional accessories.
WARNING
Only the rechargeable NiCD batteries
(part No. NiCB) can be recharged.
Warning
Maintaining The Battery Charge
As you use your radio, the battery power icon will
show the battery power remaining. When the icon
shows only one or no segment, it is time to change
the batteries.
Nothing comes close to a Cobra
•
®
®
25