Honda CRF450X 2020 Owner's Manual & Competition Handbook page 56

Fuel Tank
6. Install the fuel quick connect fitting cover (6).
Be sure the rubber cover (1) is properly
installed between the fuel quick connect fitting
cover and fuel pump.
(1)
(6)
(1) rubber cover
(6) fuel quick connect fitting cover
7. Install the harness band clip (7) to the stopper
cable guide (8).
Connect the fuel pump connector (9).
(9) (7)
(7) harness band clip (9) fuel pump connector
(8) stopper cable guide
48
Servicing Your Honda
8. Install the fuel tank (4) into the frame. Install
the washers (10) and fuel tank bolts (11), then
tighten the bolts to the specified torque.
7 lbf·ft (10 N·m, 1.0 kgf·m)
(11)
(11)
(10)
(10)
(4) fuel tank
(10) washers
(11) fuel tank bolts
9. Connect the breather tube (12) to the tube joint
(13). Install the breather tube to the tube guide
(14) onto the top shelter (15).
(13)
(12)
(8)
(15)
(12)
(12) breather tube
(13) tube joint
10. Slide the shroud (16) toward the down so that
11. Install the shroud C bolt (20), B bolt (21) and
(4)
(14)
(18)
(16) shroud
(17) tab
(18) slot
(19) side cover
12. Install the seat (page 43).
(14) tube guide
(15) top shelter
the shroud tab (17) and the slot (18) on the side
cover (19) is aligned.
shroud A bolt (22).
Tighten the shroud A and B bolts to the
specified torque:
7 lbf·ft (10 N·m, 1.0 kgf·m)
Tighten the shroud C bolt to the specified
torque:
3.8 lbf·ft (5.2 N·m, 0.5 kgf·m)
The right and left shrouds can be installed in
the same manner.
(16)
(19)
(17)
(20) shroud C bolt
(21) shroud B bolt
(22) shroud A bolt
(20)
(21)
(22)