Honda CTX700D 2018 Owner's Manual page 113

Adjust the drive chain slack.
4.
Remove the bolts and muffler end cover.
5.
P. 90
2
Install and tighten the rear axle nut.
6.
Torque: 72 lbf·ft (98 N·m, 10.0 kgf·m)
Install the muffler end cover and tighten
7.
the bolts. P. 90
2
Tighten the adjusting nuts lightly, then
8.
hold the adjusting nuts and tighten the
lock nuts.
Torque: 15 lbf·ft (21 N·m, 2.1 kgf·m)
After installing the wheel, apply the brake
9.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
P. 89
10.
2
Torque: 23 lbf·ft (31 N·m, 3.2 kgf·m)
NOTICE
When installing the brake caliper into position,
carefully fit the brake disc between the pads to
avoid scratching them.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Tire Puncture
Install the parking brake caliper and
tighten the mounting bolts.
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Use new mounting bolts when
u
installing the brake caliper.
Removing Wheels
u
109