Cobra microTALK LI5600-2DXVP Owner's Manual page 5

10289_LI5600DX_PH2 8/10/07 11:28 AM
Main Icons
Intro Operation Customer Warranty
Main Icons
Assistance
Using Your Radio
Operation
Intro Operation Customer Warranty
Channels
Channel Buttons
Assistance
With the radio on, select any of the
Secondary Icons
22 channels by pressing the Channel Up
Intro Operation Customer Warranty
or Channel Down button.
Assistance
Channel Number Both radios must be tuned to the
same channel to communicate.
Secondary Icons
Channels 1 through 7 are shared by FRS and
Notice
Secondary Icons
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 25 for FRS/GMRS frequency
allocations and compatibility charts.
Notice
Main Icons
Notice
Listening for a Response
Listening
Release the Talk button to receive incoming
transmissions. Your microTALK radio is always
in Standby mode while the Talk or
Call buttons are not pressed.
Intro Operation Customer Warranty
Call Button Assistance
Call Button
To alert another person that you are calling:
– Press and release the Call button.
The other person will hear a two second
call tone. This tone is used only to establish
Secondary Icons
voice communications.
See page 23 on how to select from
10 available call tone settings.
Notice
4
Main Icons
Page 4
Main Icons
Intro Operation
Introduction Operation
Intro Operation
Selectable High•Low Power Output
Hi-Low Button
•
When in close proximity to another party or
Secondary Icons during favorable conditions, you can switch
from High to Low Power to extend battery life.
This feature applies to GMRS Channels
Hi Power Icon
1 through 7 and 15 through 22 only.
Secondary Icons
Channels 8 through 14 operate
Notice
exclusively on low power.
Low Power Icon To toggle between high and low power:
– Press and release the Hi•Lo button.
When using Channels 1 through 7 and
15 through 22 on high power, the Hi icon
will be visible on the display.
•
When using those channels on low power
and on Channels 8 through 14, the Low icon
will be visible on the display.
To Illuminate Display
Light/Max Range
Press and release the Light/Max Range
•
button to illuminate the display for
10 seconds.
Customer Warranty
Assistance
Customer Assistance Warranty
Customer Warranty
Assistance
•
Notice
•
Nothing Comes Close to a Cobra ® 5