Danby DAS120GAHWDB Owner's Manual page 8

OPERATING INSTRUCTIONS
LOUVERS
While the appliance is on, use the swing button to
set the vertical angle of the air fl ow.
Press the swing to begin the louver movement. Press
the swing button again to stop the louver at the
desired angle.
Note that there are two swing buttons on the remote
control. One controls the up and down louver and
the other controls the side to side louver. The arrows
on the button will indicate which louver is being set.
NOTE ON LOUVER ANGLES
When using cool or dry mode, do not set the louver
at an extreme vertical angle for a long period of
time. Water can condense on the louver blade
which can then drip on the fl oor or furnishings.
When using cool or heat mode, do not set the
louver at an extreme vertical angle for a long period
of time. This can cause reduced performance due to
restricted air fl ow.
Do not force the louver to move or adjust the louver
by hand. This will cause the louver to be out of sync
and it will not function correctly. If this occurs, turn
off the appliance and unplug it for a few seconds
and then restart the appliance. This will reset the
louver position.
Do not put fi ngers in or near the blower
and suction side of the appliance. The
high-speed fan inside the appliance can
cause serious harm or injury.
7
CAUTION