Advertisement
Quick Links
MONITOR
12
1.
50/60Hz system switch
Turn the switch on or off depends on the frequency of AC power source in your
area (60 Hz in U.S.A.).
2.
V-Hold
Use to correct when the picture rolls up or down.
3.
Brightness
Adjust brightness with this knob.
4.
Contrast
Adjust contrast with this knob.
5.
Mode select switch
Select CH1, CH2, or Automatic sequencing mode by pressing this switch
continuously.
6.
CH1 indicator
This light is lit when CH2 has been selected.
7.
CH2 indicator
This light is lit when CH2 has been selected.
8.
Auto indicator
This light is lit when in the sequencing mode.
9.
Dwell time
Sequencing time can be adjusted with this slider.
10. Audio volume slider
Use this volume control to adjust proper sound level from the cameras.
6 7 8 9
5
1 0
1 1
1 2 3 4
14 15 18 19 16
13
20 21 17
Advertisement
Related Manuals for Clover OW1402
Summary of Contents for Clover OW1402
- Page 1 MONITOR 50/60Hz system switch Turn the switch on or off depends on the frequency of AC power source in your area (60 Hz in U.S.A.). V-Hold Use to correct when the picture rolls up or down. Brightness Adjust brightness with this knob. Contrast Adjust contrast with this knob.
- Page 2 11. Power ON/OFF button Turn the monitor ON/OFF. 12. Speaker Audio out. 13. DC power input jack Plug the DC 13V, 2A AC adapter (supplied) only. 14. CH1 input Connect a camera to this input jack, which has 4-pin Din. 15.
- Page 3 CAMERA Lens Adjust for the best picture by turning it clockwise or counter-clockwise. Infrared LEDs 10 Infrared LEDs let you see objects in the darkness. CDS sensor Automatically turns the Infrared LEDs on/off as needed. C-mic High sensitivity condenser microphone. 4-pin Din jack Connect one end of the cable to this jack.
- Page 4 Connect the one end of cable (supplied) to the Din jack on the rear of the camera and the other end of cable to the monitor. Make sure that two arrows on the top of them should be aimed at each other. (CAMERA) MOUNTING BRACKET...