Advertisement
FEATURES
• Heated sock liners with single zone adjustable temperature control: 5-minute Pre-Heat,
High, Medium and Low (5-minute pre-heat, high, medium and low)
• Operates on rechargeable lithium-ion batteries (2pcs 2600mAh single cell batteries)
• Includes AC adapter
HOW TO USE
1. Plug the AC adapter into an outlet.
2. Connect 2pcs batteries to the AC adapter plugs of the battery charger until it is fully charged.
The AC adapter will light up green when it is fully charged and light up red while charging.
There are two indicator lights for both batteries. Note: Do not force the plug into the battery.
3. The LED light on the AC adapter's red light indicates that it is being charged.
4. When the green light on the AC adapter lights up, the battery is fully charged. Note: Fully
charge the Heated Sock Liner's battery before using for the first time. Failure to fully charge
the battery prior to first use may reduce battery life.
5. When fully charged, disconnect the battery plug from the AC adapter.
6. Locate the input plugs inside the small pouch in each sock and connect the charged battery.
Place the battery into the pouch once connected.
7. Press and hold the control button in the sock for three to five seconds or until the LED
light flashes red [5-Minute Pre-Heat]. Pressing it again will result in a red light [High]. An
additional press will result in a white light [Medium]. Another press will result in a blue light
[Low] and will then cycle through from the initial heat setting.
8. The LED light on the control button of the sock will flash red, indicating that the sock is in
pre-heat mode once it's turned on.
9. After approximately five minutes the light will change to solid white, indicating that the sock
is no longer in pre-heat mode. The temperature can be adjusted by pressing the control
button.
10. To turn off the sock press and hold the control button for three to five seconds, or until the
LED light turns off.
11. Unplug the battery when the sock is not in use. Store battery inside the pouch of the sock
when temporarily not in use. Note: The Heated Sock Liners should only be used with the
included battery and charging cable.
TEMPERATURE SETTINGS
Red - High heat: Average 111º F with approximate run time of 2.5 hours
White - Medium heat: Average 98º F with approximate run time of 3.8 hours
Blue - Low heat: Average 88º F with approximate run time of 8 hours
Note: Above results are tested under an average temperature of 82.4º F
-2-
Advertisement
