Table of Contents
Advertisement
Intelligent automatic controll
Controller programming
Controller is factory pre-programmed as follows:
Hours
Programme
Alarm (07:00)
Out (09:30)
Back (16:30)
Night (22:30)
Setting mode of operation:
Step1
Press
to select Heating mode, press and hold
When flashing icon of programme 1 is displayed, you can change Hours of programme 1. Press
Step2
(07:00 – factory settings). Press
Step3
Press
and use
Step4
Press
to change settings of programme 2. Press
Step5
Press
and use
Step6
Press
to change settings of programme 3. Press
Step7
Press
use
Step8
Press
to change settings for programme 4. Press
Step9
Press
and use
Step10
Press
to change weekend settings. Repeat steps from 2 to 9 and press
Notice
Press
to select cooling mode and repeat all of the above steps to programme cooling mode.
To deactivate programme 2 and 3 for weekends, press
for weekends and press
ges, press
again.
Time settings: the controller is equipped with a clock, which is important to be set right. To set time, press and hold
time is flashing. By pressing
By pressing
and
set the right day of the week. Press
Resetting device to default settings: In stand-by mode, with the controller off press those buttons
seconds till „RES" symbol is displayed (display time – 5 seconds).
Button lock: Press those buttons
Fan speed setting: Press
the basis of the following settings:
- Heating: 1° C below – LOW, 2° C below – Medium, 3° C below – High
- Cooling: 1° C above – LOW, 2° C above – Medium, 3° C above – High
Heating/Cooling/Auto mode: Press
Heating: the controller controls a system of heaters. Cooling: the controller controls a system of fans. Auto: the controller controls a
system of heaters or fans depending on the outside temperature.
Heating
(Mon. – Fri.)
22°C
16°C
22°C
16°C
or
to change time to the nearest 15 minutes.
or
to set required temperature for programme 1 (22 ° C – factory settings)
or
to set required temperature for programme 2 (16 ° C – factor settings)
or
to set required temperature for programme 3 (22 ° C – factory settings)
or
to set required temperature for programme 4 (16 ° C – factory settings)
in step 6 (not
– which deactivates time settings for weekends . To reset chan-
and
set the right time. Press and hold
and
hold them for 3 seconds to lock the device (repeat to unlock the device)
to select Low
, Medium
to select Heating, Cooling or Auto mode.
FURTHER INFORMATION: HTTP://WWW.PAKOLE.HU
AFR
- WATERFAN HEATER
Cooling
(Mon. – Fri)
24°C
28°C
24°C
25°C
for 5 seconds to choose programmes for days Monday - Friday
or
to set hours (09:30 – factory settings).
or
to set hours (16:30 – factory settings).
or
to set hours (22:30 – factory settings).
in step 4 (not
till displayed day of the week is flashing.
to confirm.
or High
speed. In Auto mode
Manual
Heating
Cooling
(Sat. – Sun.)
(Sat. – Sun.)
22°C
16°C
22°C
16°C
or
to confirm.
)– which deactivates time settings
and
hold them for 5
the controller adjusts fan speed on
24°C
28°C
24°C
25°C
to set time
till displayed
23
Advertisement
Table of Contents
