Table of Contents
Advertisement
Zipper/piping insertion
A zipper and piping can be sewn in place.
Use adjustable zipper/piping foot (sold separately with some
models)
■ Inserting a centered zipper
a
f
a
Refer to step
–
of "Inserting a centered zipper"
on page 63.
b
Remove the presser foot and presser foot holder to
attach the screw-on adjustable zipper/piping foot (sold
separately with some models).
• For details on removing the presser foot holder, refer
to "Removing and attaching the presser foot holder"
on page 33.
Note
• Make sure that the thread between the spool and
the bobbin is pulled tight.
c
Select a stitch.
No.
1-01
Stitch
d
Loosen the positioning screw on the back of the presser
foot.
1
1 Positioning screw
e
Slide the presser foot over either the left or right feed
dog.
Left sewing position
Change the needle position so that the needle does not
f
touch the presser foot.
For details, refer to "Setting the stitch width/stitch
length/"L/R Shift"" on page 42.
1 Needle drop point
CAUTION
• After adjusting the needle position, slowly turn
the handwheel toward you (counterclockwise)
and check the needle does not touch the
presser foot. If the needle hits the presser foot,
the needle may bend or break.
g
Securely tighten the positioning screw.
h
Topstitch around the zipper.
1
3
2
4
1 Stitching
2 Right side of fabric
3 Basting stitching
4 End of zipper opening
CAUTION
• When sewing, be sure that the needle does not
touch the zipper, otherwise the needle may
bend or break.
i
Remove the basting stitching.
Utility Stitches
Right sewing position
1
65
3
Advertisement
Table of Contents
