Related Manuals for Clarion VMA6491
Summary of Contents for Clarion VMA6491
- Page 1 VMA6491 6.4” ACTIVE MATRIX TFT COLOR LCD MONITOR O W N E R ’ S M A N U A L INSTALLATION GUIDE...
-
Page 2: Table Of Contents
OR UNINTENDED USES OF THIS PRODUCT. NTRODUCTION The VMA6491 is a TFT active matrix color LCD monitor which delivers a strik- ing picture with superior image resolution. The VMA6491 integrates into a Clarion mobile multimedia systems using a VDH9600 (mobile VCR Recorder) even if no TTX001 (mobile TV tuner) is connected. -
Page 3: Precautions & Description O F Buttons And Connectors
VMA6491 6.4” TFT LCD Monitor RECAUTIONS • This monitor is intended for use in DC 12V, negative ground vehicles. • Do not operate the monitor in ways other than described in this guide. Doing so may cause damage and void the warranty. -
Page 4: Description Of Picture Adjustment
To adjust the picture brightness, use the Brightness UP and DOWN buttons located on the front panel of the VMA6491. Press and hold the UP button to increase the picture brightness. Press and hold the DOWN button to decrease the picture brightness (see page 2 for button locations). - Page 5 VMA6491 6.4” TFT LCD Monitor monitor will accept a video signal from any video source with composite video output. The Infrared (IR) sensor will work directly with a Clarion TTX001 or VDH9600 using the IR extension cable provided (see Application starting on page 5 for details).
-
Page 6: Applications
PPLICATIONS (With the VDH9600, TTX001 and the FM100S) 1. Pick a location to mount the TTX001 TV tuner. Typically the tuner is located close to the VCR player. Avoid areas with excessive heat or moisture. 2. Mount the TV antenna (ZCB-303 or equivalent) and plug it into the TTX001 antenna input connector. -
Page 7: Stand Alone System ( With Ttx001 And Wh100/Wh200)
2. Mount the TV antenna (ZCB-303 or equivalent) and plug it into the TTX001 antenna input connector. 3. Once a location has been determined for the VMA6491, run the 3.5 mm IR extension, video RCA and 2-pin Power Molex connector into the monitor’s... - Page 8 1. Turn the vehicle ignition switch to the accessory (ACC) position. Since the IR signals from each of the components are linked together, point the RC-300 remote control at the SENSOR located on the front of the VMA6491. 2. Press POWER on the RC-300 remote control to turn the TTX001 TV tuner ON.
-
Page 9: Description Of Rc300 Remote Buttons
VMA6491 6.4” TFT LCD Monitor RC300 R ESCRIPTION OF ATTERY NSTALLATION • Insert 2 AAA batteries into the compartment located on the back of the unit, observing the proper polarity. NOTE: Each time the batteries are changed, the remote channels must be repro- gramed. -
Page 10: Troubleshooting
ROUBLESHOOTING Symptom Cause System does not Fuse is blown. work. Power wires are not connected. The picture has The signal condi- shadows when con- tion is poor. nected TTX001. The picture has There may be inter- stripes or spots ference signals. when connected to the TTX001. - Page 11 Clarion Corporation of America 661 West Redondo Beach Blvd Gardena, CA 90247 800-Go-Clarion www.clarion-usa.com ©2000 Clarion Corporation, Gardena, CA 2000-VMA6491-10 Rev. 3 (6/00)