CAUTION:
• Do not carry out this work just after printing because the printing head is very hot.
• Be sure to turn off the power when detaching the platen roller unit.
• When eliminating remaining paper, do not touch the heating surface of the head with
a bare hand or metal piece.
• Do not detach the platen roller unit unless necessary, such as for a paper jam.
• When putting back the platen roller unit, be sure to confirm that it is correctly
reattached.
• Never detach or reattach the platen roller unit with the head-up lever lowered.
4.10 FEED Switch Function
4.10.1 When Thermal Paper is Used
Pressing the switch, feed the paper by 1 line. If the switch is held down, the paper
will be fed continuously.
4.10.2 When the Macro is Executed
If the ERROR lamp is blinking while waiting for execution of a macro, press the
FEED switch. The waiting state continues until the switch is pressed.
4.11 Paper End Function
If the printing paper runs out, the parallel interface will output BUSY, FAULT, and
PE to the host, and the serial interface will output DTR to stop printing,
respectively. If some data are still remaining in the buffer, printing will be resumed
after replacing the paper. Replace the paper according to "4.7 Inserting the Paper."
After replacing the paper, cancel BUSY (DTR), FAULT, and PE outputs. For details,
see "4.12 Paper Near End Function."
— 24 —