Table of Contents
Advertisement
M U L T I - V I E W R E A R C A M E R A
For added convenience, the area behind your vehicle is displayed to help you
navigate while backing up.
H o w I t W o r k s
• When you shift into Reverse (R), a real-time
image of the area behind your vehicle is shown
in the navigation display.
• Yellow parking guide lines also appear to help
you judge distance.
• The rearview display turns off when you shift out
of Reverse.
A d j u s t i n g t h e V i e w
T u r n i n g t h e G u i d e L i n e s
O n o r O f f
Press and hold CANCEL for
about 3 seconds. If the guide
lines are turned off, they remain
off until turned on again.
14
S w i t c h i n g V i e w s
There are three rearview modes:
wide, normal, and top down.
• Press ENTER to toggle between
views.
• Rotate the Interface Dial to
adjust the screen brightness.
Wide
Wide
Normal
Top down
Normal
Top down
H O M E L I N K ®
Program your vehicle to operate up to three remote-controlled devices around your
home, such as garage doors, lighting, or home security systems.
T r a i n i n g a B u t t o n
1
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.
2
Press and hold the desired HomeLink
button and the button on the remote
transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
NO
a
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
NO
If you have any problems programming HomeLink, see the owner's manual
included with the device you are trying to program, call HomeLink at
(800) 355-3515, or visit www.homelink.com.
3
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
NO
4
Press and hold
complete
the HomeLink
button again.
HomeLink indicator
YES
HomeLink LED
flashes for 2 seconds,
remains on.
then remains on.
a
The remote has a rolling code.
Press the "learn" button on the
remote-controlled device (e.g.,
garage door opener).
b
Within 30 seconds, press and hold
the programmed HomeLink button
YES
for 2 seconds.
5
Press the programmed HomeLink
button again; the remote-controlled
device should operate.
YES
Training
15
11
Advertisement
Table of Contents
