Step 2 - Cisco 7201 Quick Start Manual

Cisco 7201: quick start

Hide thumbs Also See for 7201:

Table of Contents

Connect an AC-input power supply as follows:

Figure 18

Connecting AC-Input Power

AC power receptacle

At the front of the router, check that the power switch is in the standby (|) position.

Step 1

Step 2

Swing the wire cable-retention clip to the left.

Plug the power cable into the AC connector of the power supply.

Step 3

Slide the cable-retention clip to the right, so that the power cable is held by the cable-retention clip.

Step 4

Plug the AC power supply cable into the AC power source. Repeat these steps if you have a dual-AC power supply.

Step 5

Step 6

On the front of the router, place the power switch in on (O) the router to turn on the router.

After powering off the router, wait a minimum of 30 seconds before powering it on again.

Note

If required, use Sinewave Output UPS (uninterruptable power supply), not Ferro-resonant type UPS.

This completes the procedure for connecting AC-input power. Your installation is complete. Proceed to the

section on page 29

to start the router and to perform a basic configuration.

Adjustable AC power cable-retention clip

"Start the Router"

Table of Contents

Table of Contents