Cisco 3745 Quick Start Manual page 20

Enter a hostname for the router (this example uses 3745):
Step 3
Configuring global parameters:
Enter hostname [Router]: 3745
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This
password, after entered, becomes encrypted in the configuration.
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the
Step 4
configuration:
Enter enable secret: xxxx
The enable password is used when you do not specify an enable secret password, with some older software
versions, and some boot images.
Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)
Step 5
and can be seen when viewing the configuration:
Enter enable password: xxxx
The virtual terminal password is used to protect access to the router over a network interface.
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the
Step 6
console port:
Enter virtual terminal password: xxxx
Step 7 Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]: yes
Community string [public]:
Step 8 A summary of the available interfaces is displayed:
Note The interface numbering that appears is dependent on the type of Cisco modular router platform and on the
installed interface modules and cards.
Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 3/0 24
T1 3/1 24
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
FastEthernet0/0
FastEthernet0/1
Step 9 Select one of the available interfaces for connecting the router to the management network:
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Step 10 Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]:
IP address for this interface: 10.1.1.1
Subnet mask for this interface [255.0.0.0] : 255.255.0.0
Class A network is 10.0.0.0, 16 subnet bits; mask is /16
20
23 pri/channelized
23 pri/channelized
IP-Address OK? Method Status
unassigned NO
unassigned NO
Administratively up
Administratively up
unset up
unset up
Protocol
down
down