Advertisement
Quick Links
Installation
A pendant head (AM-114) is required.
You can either use standard pendant pipes, AM-116 (20cm) and AM-117 (40cm).
AE-153
AE-153 Installation Guide
(Weather-proof Housing and Bracket for
SC8131)
AM-117
184
QIG part no.: 625044900G
AM-114
473 mm
VIVOTEK
Installation Guide
Advertisement
Related Manuals for Vivotek AE-153
Summary of Contents for Vivotek AE-153
- Page 1 VIVOTEK AE-153 Installation Guide (Weather-proof Housing and Bracket for SC8131) QIG part no.: 625044900G Installation A pendant head (AM-114) is required. You can either use standard pendant pipes, AM-116 (20cm) and AM-117 (40cm). AM-114 473 mm AM-117 AE-153 Installation Guide...
- Page 2 VIVOTEK AM-116, AM-117 Mechanical Drawings 1 1/2" PS11 n 50.8 1 1/2" PS11 n 50.8 Installing the Pendant Head and Pendant Pipe 1. Determine a hard surface ceiling location, and use the included alignment sticker for marking three mounting holes as where the holes will be drilled to secure the pendant head.
- Page 3 6. Install the AE-153 top bracket. 7. Secure the installation by tightening the socket hex screw. AM-114 AM-117 AE-153 8. Prepare the AE-153 bracket components. The components are shown below: Cable gland Slide bracket Thermal pads This side with a model name tag.
- Page 4 VIVOTEK 9. Route a CAT5e Ethernet cable through the pendant pipe, and install the cable gland components to the Ethernet cable. Sliding edge towards the clamp head. 10. Remove the side cover from the side with a name tag, and remove slide bracket from the chassis.
- Page 5 VIVOTEK 12. Attach 4 thermal pads to the 4 corners on the back of the SC8131 camera. 13. Place the slide bracket on top of the camera. The opening should provide access to the indented area on the back of the camera. Make sure another long piece of thermal pad is properly installed on the slide bracket.
- Page 6 VIVOTEK 15. You can install the waterproof cable gland to chassis. Leave some of the Ethernet cable at the outside of the chassis for making the connection. Do not completely tighten the cable gland yet. 16. Before you install the camera into chassis, remove the protective sheet from the camera.
- Page 7 VIVOTEK 18. Secure the slide bracket by driving an M3 screw. 19. Tighten up the cable gland, adjust the cable length, and install the side cover. 20. Secure the chassis to bracket by driving 4 M3 screws. Installation Guide...
- Page 8 VIVOTEK 21. Loosen the hex socket crew and adjust the orientation, the shooting angle, or the tilt angle if necessary. 22. Remove the protective sheet from the bottom of the chassis. 8 - Installation Guide...