Table of Contents
Advertisement
REPLACEMENT PARTS
Ordering Parts
When reporting shortages or damages, or ordering repair parts,
give the complete unit model and serial numbers as stamped on
the unit's nameplate.
Replacement parts for this appliance are available through your
contractor or local distributor. For the location of you nearest
distributor, see website www.daikinac.com or contact:
EQUIPMENT SUPPORT
DAIKIN NORTH AMERICA LLC
19001 KERMIER ROAD
WALLER, TEXAS 77484
855-770-5678
SAFETY INSTRUCTIONS
To The Installer
Before installing this unit, please read this manual to familiarize
yourself on the specific items which must be adhered to, including
maximum external static pressure to unit, air temperature rise,
minimum or maximum CFM and motor speed connections.
Keep this literature in a safe place for future reference.
Safety Considerations
IMPORTANT NOTE: This unit is designed to meet the NOX
requirement of 14Ng/J maximum as required by the South Coast
Air Quality Management District and the San Joaquin Valley Air
Pollution Control District, both in the State of California, and is
intended for installation in those districts only.
This unit has a Control System that compensates for certain
installation and environmental conditions. This unit must:
•
Be properly installed, operated, and maintained per the
instructions.
•
Be serviced only by properly trained Service Technicians.
This unit is not approved for use with gases other than Natural
Gas.
Units that are not installed, maintained, or operated properly may
result in "noisy" operation during the Heating Cycle. If this unit is
making unusual or objectionable noises during the Heating Cycle,
turn the heat off at the thermostat and contact a qualified Service
organization right away.
Adhere to the following warnings and cautions when installing,
adjusting, altering, servicing, or operating the furnace. To ensure
proper installation and operation, thoroughly read this manual
for specifics pertaining to the installation and application of this
product.
This furnace is manufactured for use with natural gas only.
Never test for gas leaks with an open flame. Use commercially
available soap solution made specifically for the detection of
leaks to check all connections, as specified in GAS PIPING
section of this manual.
Always install a furnace to operate within the furnace's intended
temperature-rise range with a duct system which has external
static pressure within the allowable range, as specified on the
rating plate.
If the information in these instructions is not
followed exactly, a fire or explosion may result
causing property damage, personal injury or
loss of life.
- do not store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions. If you cannot reach your gas
supplier, call the fire department.
- Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
Should overheating occur or the gas supply fail
to shut off, turn off the manual gas shutoff
valve external to the furnace before turning off
the electrical supply.
Do not connect to or use any device that is
not design certified by the manufacturer for
use with this unit. Serious property damage,
personal injury, reduced unit performance and/
or hazardous conditions may result from the use
of such non-approved devices.
3
WARNING
WARNING
WARNING
Advertisement
Table of Contents
