Epson EH-TW2900 Service Manual page 60

EH-TW3500/4500/5500
6. Remove the six screws and remove the Inner Upper Cover from the Upper Case
(assembly).
7. Remove the two screws ( ) and remove the Lamp Latch Cover from the Upper
Case (assembly).
8. Remove the Latch Spring from the Lamp Latch Cover.
9. Remove the Logo Plate Base from the Upper Case (assembly).
10. Remove the EX Seal from the Upper Case (assembly).
Inner Upper Cover
Upper Case
(assembly)
EX Seal
Logo Plate Base
SEIKO EPSON
Lamp Latch Cover
Latch Spring
C.C.P-TITE SCREW,3X8,F/ZB-3C
Figure 3-9.
Disassembly and Assembly
When reassembling the Lamp Latch Cover and Latch Spring, follow the
procedure below.
1. Insert the Latch Spring into the attachment location until the spring is firmly
secured into the pin.
2. Place the Lamp Latch Cover on the Upper Case (assembly) correctly, then
install the end of the spring into the Spring holder adjusting it from the slit on
the Lamp Latch Cover.
3. Secure the Lamp Latch Cover with the screws.
Backside
Pin
60
Upper Case (assembly)
Latch Spring
Lamp Latch Cover
CONFIDENTIAL
Spring holder
Revision A