Switching The Power Source; Figure 2.7-1 Jumper Switch For The Power Supply Route; Table 2.7-1 How To Switch The Emulator-Specific Power Supply Circuit Pin - Fujitsu MB2145-507 Hardware Manual

2.7

Switching the Power Source

Configure the system by selecting the power supply route to the evaluation MCU
according to Tables 2.7-1 and 2.7-2.
Switching the Power Source
Set the jumper switch for the power supply according to whether there is an emulator-specific
power pin(*1) on the evaluation MCU.
*1 For the models equipped with emulator-specific power supply, contact the Fujitsu sales
division.

Table 2.7-1 How to Switch the Emulator-specific Power Supply Circuit Pin

Emulator-specific power supply circuit pin
CAUTION
Prohibition Before setting the jumper switch for the power supply, turn off the
power.
Failure to do so may cause an electric shock.
*1 Jumper switch for the user power supply port 0
*2 Jumper switch for the user power supply port 1
*3 Jumper switch for the emulator-specific power supply circuit pin

Figure 2.7-1 Jumper Switch for the Power Supply Route

Yes
No
2.7 Switching the Power Source
S2 setting
B-C shorted (+5 V side)
A-B shorted (UVCC1 side)
25