Sharp CD-DP2500H Operation Manual page 30

(Continued)
Downloaded from: http://www.usersmanualguide.com/
Recording from the built-in radio
1
Tune in to the desired station. (See pages 17-18.)
2
Load a cassette into the TAPE 2 cassette compartment.
3
Press the REC PAUSE (
"REC" will flash.
4
Press the 0/R (TAPE 2 0) button.
"REC" will appear.
Note:
If a whistling noise is heard whilst recording from an AM
station, move the AM loop aerial to a position where noise
is no longer heard from the unit.
To stop recording:
Press the (TAPE ) button.
Dubbing from tape to tape
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette com-
partment. Insert a blank tape into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape be the same
length as the master tape.
3
Press the TAPE (1 V 2) button until "TAPE 1" appears in
the display.
4
Press the REC PAUSE (
5
Press the 0/R (TAPE 2 0) button.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
Make sure that TAPE 1 is not in use.
1
Load the tape to be erased into the TAPE 2 cassette com-
partment.
2
Press the TAPE (1 V 2) button until "TAPE 2" appears in
the display.
3
Press the REC PAUSE (
4
Press the 0/R (TAPE 2 0) button.
29
6) button.
6) button.
6) button.