Audio Operations; Back-Up Memory Function; Sleep Timer Operation; Basic Operations - Teac AG-780 Owner's Manual

AUDIO OPERATIONS

Back-up Memory Function

BACK-UP Memory
This is the function which preserves the preset memory
and most-recent memory functions. In the event of a
power failure, or if the power cord of this unit is discon-
nected from the electric outlet, the back-up memory will
preserve the preset memory and most-recent memory
functions for as long as approximately 3 days.
To Prevent Erasing the Memory
If the power supply is interrupted for 3 days or longer,
the memory settings will be erased.
Note:
The following points apply throughout the "AUDIO
OPERATIONS" sections unless otherwise noted.
● To simplify explanations, instructions refer to
names of buttons and controls on the front panel,
making no mention of the use of remote control
unit.
● To listen to a source other than tape deck, press
the TAPE MONITOR button to the OFF position
(the tape monitor indicator (TAPE 2) will not light
in the display).

Sleep Timer Operation

SLEEP Timer Function
This function allows you to preprogram the receiv-
er to switch its own power off automatically. You
can then enjoy the audio system for a specified
amount of time without having to worry about turn-
ing the unit off later.
Each press of the SLEEP button changes the time
indication by 10 minutes.
∑ SLEEP 90 ∑ SLEEP 80 ∑ ... ∑ SLEEP 10
(Released condition)ß
To let the remaining time (until power off) appear
on the display while the sleep timer is engaged,
press the SLEEP button once.

Basic Operations

1. Press the POWER button to ON.
2. Select the desired source with the source selector but-
tons.
3. To adjust the tone or the balance between the left and
right channels,
BALANCE button, then turn the JOG dial until the
desired level appears in the display.
4. Set the LOUDNESS button to the OFF position.
5. Select the speaker system to be used with the SPEAK-
ERS select buttons (speakers "A" and "B" can also be
selected simultaneously).
6. Start playing the source component.
7. Gradually turn up the volume to the required level
with the VOLUME control.
– 11 –
press the BASS, TREBLE or