Table of Contents
Advertisement
3
• Slide axle into holes at ends of legs (legs
without end caps).
• Attach wheels onto axle rod using hitch
pins. Hitch pins insert through hole in axle
as shown in box A.
Check to be sure that all screws and nuts
used so far are fully tightened.
Hitch Pin
Axle
4
•
Pre-assemble the Firebox Lid and the Firebox
Bottom using eight #6-32 X 3/8 Screws as
shown in figure A.
• Place the firebox onto the smoker chamber and
align the large openings.
• Insert eight #10-24 X 1/2" screws through the
smoker chamber, into the firebox. Secure with
eight #10-24 flange nuts as shown in figure B.
Fully tighten all screws and nuts.
Firebox Lid
Eight
#6-32 X 3/8
Screws
Firebox Bottom
Hitch Pin
Figure A
Wheel
Axle
Legs with
holes
Figure B
Hitch Pin
Wheel
Smoker
Chamber
#10-24 X 1/2
Firebox
Eight
#10-24
Flange
Nut
Eight
Screws
Page 9
Advertisement
Table of Contents
