SkyLink KN-318 User Manual

WIRELESS KEYLESS ENTRY MODEL KN-318 PRELIMINARY COPY
Congratulations on your purchase of the Skylink® Wireless keypad Model KN-318. The Model
KN-318 works with the Skylink® Smart ButtonTM or receivers. In this package, you will find a
wireless keypad with 1.5V AAA battery and screws.
The keypad transmitter can operate up to 4 Smart ButtonTM units, that also means one keypad
transmitter can operate up to 4 garage door openers.
Same PIN will be used for all doors. The factory default password is [0 0 0 0].
To operate door 1, you will enter [0 0 0 0][#][1]
To operate door 2, you will enter [0 0 0 0][#][2]
To operate door 3, you will enter [0 0 0 0][#][3]
To operate door 4, you will enter [0 0 0 0][#][4]
To program the keypad transmitter into the Smart ButtonTM, you must decide which door you
need to operate. If you only have one Smart ButtonTM, we suggest you to use door 1. i.e. [0 0 0
0][#][1]. Follow the instructions below to program the keypad transmitter.
Follow the instructions below to change the PIN.
To change your PIN:
1. Enter the current PIN, (factory default PIN 0 0 0 0), press * .
2. Enter new 4 to 6 digit PIN, press * .
3. Enter new PIN again, press * .
For example, if you are changing the PIN number from 0000 to 123456, enter the following
sequence, 0000, *, 123456, * , 123456, * . If confirmed, the balcklit LED flashes and the unit emits
a long beep.
One 1.5 volt AAA type battery (included).
It is time to change the battery when the backlight no longer appears.
The Wireless kepad is approved by the FCC and it complies with
FCC
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux Partie 15 des règlements de la FCC et CNR d'Industrie
Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.