IBM xSeries 240 81Y Hardware Maintenance Manual page 81

user name and password combination that has been
previously configured for use with the System
Management processor. You can use one of two
user name and password combinations:
The default user name (USERID) and password
(PASSW0RD)
Note
The default user name and password are
case sensitive. You must use ALL CAPS,
and the "0" in PASSW0RD is the numeral
zero.
A user name and password that you define using
the System Management processor and Netfinity
Manager
Note
The user name and password can also be
defined using the configuration utility. See
"Dial In/Out Settings" on page 65.
Important
For security purposes, change the user name
and password using the System Management
processor.
If you update the System Management processor
microcode, the default user name (USERID) and
password (PASSW0RD) are reset. If you had
previously changed them, you will need to
change them again.
When you have logged into the System Management
processor, the following main menu appears:
2 Monitors
3 Error Logs
4 Service Processor Configuration
5 System Services
6 System Power
7 Boot
B Remote Terminal Status
Y Disconnect Current Logon
Z Start Remote Video
3. Select 7 Boot.
The following Boot menu appears:
1 Reboot w/OS Shutdown
2 Reboot immediately
4 Restart SP
4. Select a Boot menu item.
Select 1 Reboot w/OS Shutdown to shut down
the server operating system and then restart the
server.
73
xSeries 240