Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain WD832KD Owner's Manual

1/2 hp security+ garage door opener
Hide thumbs Also See for WD832KD:
Table of Contents

Advertisement

PROGRAMMING

NOTICE: If this Security ✚
receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the
copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to
circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door
will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in the

To Add or Reprogram a Hand-held Remote Control

USING THE MULTI-FUNCTION DOOR CONTROL
9
1
9
1
7
3
7
3
5
5
KG
KG
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
Multi-Function Door Control.
3. Continue holding both buttons while
you press the push bar on the
Multi-Function Door Control (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
If provided with your garage door opener, the large
button is factory
programmed to
operate it. Additional
buttons on any
Security✚
remote or compact
remote can be
programmed to
operate other Security✚
35
®
remote controls.

*3-Button Remotes

®
3-Button
®
garage door openers.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Whisper drive wd832kd

Table of Contents