Philips ME5P Service Manual page 18

18
ME5P 23"
Go to cover page
STATUS
On
Stand-by
Suspend
Off
Power switch off
TV mode
The power consumption and the status indication of the set
with power management function are as follows,
STATUS
On
Stand-by
In Monitor power saving mode,
Which no H&V sync or absent either H-sync or V-sync input via VGA connector.
The monitor will enter "Monitor saving mode". The way to wake up or change
source:
1. H-sync and V-sync have signal again.
2. Press "AV" key on remote control, change to video source directly via OSD tree.
In TV power saving mode,
Which switched off by RC "Power" key, SLEEP TIMER function or no TV signal
input for 30 minutes, the monitor will enter "TV standby mode" and LED shows
Red color. The way to wake up:
Press "Power" key on remote control to return original video source.
4.0 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined under the following
conditions.
(1) Input signal
(2) Luminance setting: controls to be set to 500 Nits (typical) with
2005-07-01
Yikuan YU
GENERAL PRODUCT SPECIFICATION
Horizontal
Vertical
Pulse Pulse
No Pulse Pulse
Pulse No Pulse
No Pulse No Pulse
-
Typical
Power switchoff
: As defined in 3.3.1.5, 1280 x 768 x 60Hz
non-interlaced mode (47.776kHz), signal
sources must have 75 ohm output impedance.
full screen 700mv white signal.
23" Wide LCD Monitor/TV
BRAND: Philips
2005-07-01
Typical
-
Power Spec
230V LED
AC
95W Green
< 1 W
Red
< 1 W -
25 590
230V LED
AC
75W Green
< 1W
Red
< 1W
Red
< 1 W Red
< 1 W
-
16