Chamberlain Power Drive PD458D Owner's Manual page 5

Planning (Continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require
reinforcement. If your door is lightweight, refer to
the information relating to sectional doors in
Installation Step 12.
• Depending on your door's construction, you may
need additional mounting hardware for the door
bracket (Step 12).
ONE-PIECE DOOR WITHOUT TRACK
Header Wall
Gap between floor
and bottom of door must not exceed 1/4" (6 mm).
Safety Reversing Sensor
ONE-PIECE DOOR WITH TRACK
Gap between floor
and bottom of door
Safety
must not exceed 1/4" (6 mm).
Reversing Sensor
Rail
Wall-mounted
Door Control
Access
Door
Safety Reversing
Sensor
Header
Wall
Access
Door
Garage
Door
Safety
Reversing
Sensor
5
WARNING
Without a properly working safety reversal system,
persons (particularly small children) could be
CAUTION
SERIOUSLY INJURED or KILLED by a closing garage
door.
• The gap between the bottom of the garage door and
the floor MUST NOT exceed 1/4" (6 mm). Otherwise,
the safety reversal system may not work properly.
• The floor or the garage door MUST be repaired to
eliminate the gap.
Motor unit
CLOSED POSITION
Header
Rail
Bracket
Bracket
Garage
Door
Spring
Straight
Door
Arm
Header
Curved
Wall
Door
Door
Garage Arm
Bracket
Door
CLOSED POSITION
Rail
Bracket
Header
Curved
Bracket Door Arm
Door
Straight
Bracket
Door
Arm
Emergency Release
Rope & Handle
Rail Assembly
Trolley
Emergency
Release
Rope & Handle
Trolley
Rail Assembly