Table of Contents
Advertisement
Installation Step 7
Install the Light and the Lens
Install the Light
• Install a 75 watt maximum light bulb in socket. The
light will turn ON and remain lit for approximately
4-1/2 minutes when power is connected. Then the
light will turn OFF.
• If a bulb burns out prematurely due to vibration,
replace with a "Garage Door Opener" bulb.
Install the Lens
• Locate and loosen (approximately 1/8") the two
screws near top of opener front panel. Position
lens against panel with slotted tabs directly below
screws. Slide lens up to seat tabs behind screws.
Snap bottom tabs of lens into panel slots.
Retighten top panel screws to secure lens.
Installation Step 8
Attach the Manual Release
Rope and Handle
Trolley
Rope
Overhand
Knot
Overhand
Knot
Trolley
Release Arm
Manual
Release Handle
19
Light
Lens
Lens Tab
WARNING
Do not use the red handle to pull the door open
or closed. The rope knot could become untied
and you could fall. Use the manual release only
to disengage the trolley and, if possible, only
when the door is closed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could close
inadvertently if it is not properly balanced.
Serious injury may result to persons under the
door. Make sure the doorway is clear of
persons and obstructions before pulling handle
when door is open.
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at least
1" from the end of the rope to prevent slipping.
• Thread the other end of the rope through the hole in
the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the cut end
with a match or lighter to prevent unraveling.
Panel Screw
Lens Slot
75 Watt Max.
Light Bulb
Advertisement
Table of Contents
