Chamberlain 920GA User Manual

WIRELESS GATEBELL KEYPAD
MODEL 920GA
LEARN
CARTON INVENTORY
PRESS
TO
Remote Control
PRESS
RING
TO
PRESS
RING
Receiver TO
RING
Keypad
PRESS
TO
RING
Drywall Anchors (2)
INSTALLATION • MOUNT RECEIVER
TABLETOP MOUNTING
1
LEARN
Insert remote control and power
adapter into receiver. Plug into outlet.
®
INSTALLATION • MOUNT KEYPAD
NOTE: For optimal range performance, mount the receiver to an external wall that is close to the gate operator. DO NOT MOUNT TO METAL.
1
PRESS
TO
R ING
PRESS
TO
Program remote control to the gate
RING
operator radio receiver. Refer to your
gate operator manual for programming
instructions.
PRESS
TO
R ING
Power Adapter
3
Screws (4) Bottom
Mounting
Hole
Remove battery cover and battery.
Determine location for keypad. Mark
the bottom mounting hole.
5
Install top mounting screw, allowing
1/8" (3.2 mm) to protrude above surface.
Position keypad on screw head and adjust
for snug fit.
PRESS
TO
RING
Lift
Battery
Battery Cover
LEARN
LEARN
2
PRESS
TO
R ING
Remove foam spacer on underside of
keypad cover. Check range before installing.
Using two people, hold the keypad and
receiver in the desired locations. Make sure
the keypad rings the gatebell when pressed.
If no chime is heard, repeat test using a new
location for the receiver.
4
Top Mounting Hole
LEARN
For the top mounting screw, mark 4
1/4" (10.8 cm) up the centerline from
the bottom of the keypad. Drill 1/8"
pilot holes for top and bottom screws.
See keypad mounting reference.
6
LEARN
LEARN
LEARN
Secure keypad with bottom screw, using
care to avoid cracking plastic housing. LEARN
Reinstall battery and slide battery cover
up and snap it into place. Close cover.
KEYPAD MOUNTING
(For reference only)
LEARN
4 1/4"
(10.8 cm)
LEARN
LEARN
LEARN
LEARN
LEARN
LEARN
LEARN
LE
LEARN
L
LEARN