Care And Cleaning - Capital Performance Series PSQSB2000 Use And Care Manual

caring for your side burner:
IMPORTANT!
Stainless steel tends to rust in presence of chlorides and sulfides specifically
in coastal area. To ensure rust prevention, wash all stainless steel surfaces
every 3-4 weeks with fresh water and condition with stainless steel cleaner.
11
7
Side Burner Cleaning:
BEFORE REMOVING: ensure the gas supply is turned off and the knobs are in
the "OFF" position. Make sure the grill is cool. Remove the top grate. Lift and
remove the burner caps and clean sealed pan with a mild soap and warm water
cleaner. Clean burner base with a soap and warm water solution. Burner ports
may be cleaned with a straightened paperclip.
Burners:
Each burner is constructed of a porcelain coated cast iron top cap coupled with
an aluminum burner containing ports and an aluminized base. The burners are
sealed, which means that spills are contained in a sealed top section for easy
cleanup. Frequency of cleaning will depend upon the climate and location, and
how often you use the grill. If spill deposits, grease residue, and dust are
allowed to collect over time, the presence of these materials can seriously
jeopardize burner performance. It will be necessary to clean out the burner
ports using a thin wire, needle or straightened paper clip.
Stainless Steel:
The PSQSB200 is constructed out of non-rusting and non-magnetic stainless
steel. After initial usage, areas of the side burner may discolor from the intense
heat given off by the burners: this condition is normal. There are many different
stainless steel cleaners available. Always use the mildest cleaning procedure
first, scrubbing in the direction of the grain. To touch up noticeable scratches in
the stainless steel, sand very lightly with dry 100 grit emery paper in the
direction of the grain. Specks of grease can gather on the surfaces of the steel
and bake on to the surface giving a "rust-like" appearance. For removal, use an
abrasive pad in conjunction with a stainless steel cleaner. Always rub in the
direction of the grain.
Battery Replacement:
• Battery location is indicated on the front panel
• Flip the battery service panel up
• You will see a 9 volt battery ready for
replacement
• Pull battery out and replace
• Push to snap in
Note: battery condition should be checked
at least once a year.