Canon LV-8225 User Manual page 56

Setting
Terminal
The COMPUTER IN /MONITOR OUT terminal on the
back of the projector is switchable for computer input or
monitor output (p.11). Select COMPUTER 2 or Monitor
Out with the Point ▲▼ buttons.
COMPUTER 2 ....... computer input
Monitor Out ....... monitor out
Terminal function is not available when selecting
COMPUTER 2 to the input source. Change the input
source to the others (COMPUTER 1, and so on) so that
the Terminal function will be available. (pp. 8,41,4)
Power management mode
For reducing power consumption as well as maintaining
the lamp life, the Power management mode function
turns off the projection lamp when the projector is not
operated for a certain period.
Select one of the following options:
Standby ...........
When the lamp has been fully
cooled down, the POWER
indicator changes to green
blinking. In this condition, the
projection lamp will be turned on
if the input signal is reconnected
or any button on the top control or
remote control unit is pressed.
Exit ................... When the lamp has been fully
cooled down, the power will be
turned off.
Off .................... Power management mode
function is off.
Timer ................ If the input signal is interrupted
and no button is pressed for
more than 30 seconds, the timer
display with No signal appears.
It starts the countdown until the
lamp is turned off. Use the Point
▲▼ buttons to set the Timer
(1~30min).
Note:
Factory default is Standby: 5 min.
Direct power on
When this function is set to On, the projector will be
automatically turned on just by connecting the AC
power cord to a wall outlet.
Note:
• Be sure to turn off the projector properly
(see "Turning Off the Projector" on page
3). If the projector is turned off in the
incorrect sequence, the Direct power on
function will not work properly.
56
Power management mode
Time left before Lamp is off.