Canon LV-5200 Owner's Manual page 37

Power management
This function turns the Projection Lamp off when this projector
detects a signal interruption and is not used for a certain period in
order to reduce the power consumption and maintain the Lamp-life.
(This projector is shipped with this function ON.)
The Power Management function operates to turn the Projection
Lamp off when the input signal is interrupted and any button is not
pressed over 5 minutes. This function operates as follows;
1. When any input signal is interrupted, "No signal" and the count
down display appears (for 5 minutes).
2. After counting down for 5 minutes, the Projection Lamp and the
READY Indicator are turned off. (Cooling Fans keep running.)
3. The READY Indicator starts to flash after cooling down the
Projection Lamp about for 90 seconds (Power Management
mode).
In this Power Management mode, the Projection Lamp is
automatically turned on when the input signal is connected or
the projector is operated with any button on the Top Control or
on the Remote Control Unit again.
On start
When this function is "On," the projector is automatically turned on
just by connecting the AC Power Cord to an AC outlet.
NOTE : Be sure to turn the projector off properly (refer to the section
"TURNING OFF THE PROJECTOR" on P19). If the
projector is turned off in the wrong steps, the On Start
function does not operate properly.
Lamp mode
When selecting the " " (Silent), the projector reduces the
brightness and sets into the low power consumption mode.
Remote control
This projector has two different remote control codes; the factory-set
normal code (Code 1) and the secondary code (Code 2). This
switching function prevents remote control interference when
operating several projectors or video equipment together.
When operating the projector in "Code 2," both the projector and the
Remote Control Unit must be switched to "Code 2."
To change the code of the Projector;
Set the Remote control in the SETTING Menu to "Code 2."
To change the code of the Remote Control Unit;
Press both the MENU and the IMAGE buttons on the Remote
Control Unit together for over 10 seconds.
After changing the code, make sure the Remote Control Unit
operates properly.
To return to the normal code (Code 1), repeat the steps above.
NOTE : When the batteries of the Remote Control Unit are replaced
or ALL-OFF switch is turned to "ALL-OFF," the remote
control code automatically returns to the normal code (Code
1).
Lamp counter reset
This function is used to reset the Lamp Replace Counter. When
replacing the Projection Lamp, reset the Lamp Replace Counter by
using this function. Refer to page 39 for operation.
Time left until Lamp off.
Press the SET button at
this icon to display other
items.
Press the SET button at
this icon to display the
previous items.
Move the pointer to the
item and then press the
POINT LEFT/RIGHT
button(s).
SETTING
37